Why is the water stain nowhere near the roof leak?
Because water runs along whatever it lands on. It enters at a high point, follows a rafter, a top plate, a duct or the slope of the ceiling, and emerges where it finds a seam, a fixture or a joint. That is why the attic is inspected and mapped rather than just the ceiling below.
The practical consequence is that repairing the roof directly above a stain is a coin toss. A technician works the other way: find the wet area in the attic, follow it uphill against the slope to the highest wet point, and look for the entry there. Daylight, staining on the deck and a wet rafter top are the markers.
It also explains why a leak can be fixed and the ceiling still stain once more. Water already in the insulation and the cavity keeps moving for a while after the entry is closed. Removing the wet insulation and drying the cavity is what stops the encore, and skipping it is the usual reason a household repaints twice.
What happens to wet attic insulation?
It is removed. Batt and blown insulation that has absorbed water holds it against the top of the ceiling, loses most of its insulating value while compressed and wet, and dries very slowly in a confined attic. Taking it out lets the crew read and dry the framing and the ceiling properly.
Wet insulation is also heavy, and that is part of the hazard. A ceiling designed for the weight of dry insulation and drywall can be carrying a great deal more after a storm, which is one reason a bowed ceiling is treated as a structural risk and not a cosmetic one.
Replacement is a rebuild decision taken after the space is dry, not during the dry-out. Putting new insulation back over a cavity that still reads wet traps the moisture and starts the sequence again. The crew will tell you where the readings are so that the insulation contractor is not working blind.
Do storms around Crystal Lake cause roof leaks and flooding at the same time?
They can, and both have happened here. Heavy rain that overloads drainage also tests roofs and gutters. In August 2007, 11 to 12 inches of rain over successive events put Crystal Lake at its highest recorded level with storm sewers at capacity, and large storms still flood Pine Street and Oriole Trail.
A household that takes water from above and below in the same storm has two different jobs running at once, and it is worth separating them early. Roof water arrives through the attic and the ceilings; storm water arrives at the lowest floor through drainage, window wells or the storm sewer system. The materials affected, the water category and the claim conversation are all different.
This area's drainage story is specific. The lake has no spring, stream or river feeding it and collects runoff from a watershed of roughly 2,300 acres, mostly north of the lake; the City's stormwater study work named the North Shore, where runoff reaches the lake through old and inadequate storm sewer, and part of Crystal Creek was buried in a storm sewer, probably in the 1950s, causing flooding upstream. Along the Fox, the river at Algonquin holds a record stage of 12.70 ft set on 23 April 2013 against a flood stage of 9.5 ft, and in July 2017 it ran near or above that record with about 800 McHenry County buildings reported flooded.
If the basement is wet as well as the ceiling, say so when you call. The downstairs scope is on the basement flooding after heavy rain page, and a crew can plan one visit around both rather than two around one each.
What drives the cost of a roof leak dry-out up or down?
How far the water traveled, how much insulation and ceiling has to come out, how many rooms and stories are involved, attic access, whether the roof is still letting water in, and how long the drying runs. Height and a steep or complex roof add work. The scope is explained and approved before any work starts.
A single wet bay over a hallway is a small job: a limited opening, a bag of insulation, a few days of equipment. A leak that ran along a top plate over three rooms, soaked blown insulation across a whole attic and came down two walls is a different scope entirely, and the difference is in the attic rather than in the stain.
Access shapes the rest. A walk-up attic with decking is quick to work in; a low truss attic reachable only through a hatch, full of ductwork and blown insulation, is slow, hot and awkward, and everything removed has to come out through the house. Two-story work adds protection of the floors below.
The roof itself sits outside this price, because it is roofing work. We will say what has to happen and in what order, and you should get a written, signed contract for the repair portion before it starts. Illinois licenses roofers through the Illinois Department of Financial and Professional Regulation, whose license search lets you check a contractor before you sign. No figures are published on this site for either side of the job.
Should I have the roof repaired before the ceiling is dried?
The entry has to be stopped or covered first, yes, but the roof does not have to be fully rebuilt before drying starts. A temporary cover and a dry forecast are enough to begin removal and drying. What cannot happen is equipment running under a roof that is still delivering water with every rain.
In practice the sequence is: stop or cover, remove wet insulation and failed ceiling material, dry to a reading, then repair the roof and rebuild the ceiling. Doing the rebuild first hides a wet cavity behind new drywall, which is the most expensive mistake available in this particular job.
Keep the two sets of paperwork together. Photographs of the attic and the ceiling before anything was removed, the moisture log, the removal list and the roofer's findings all belong in the same file, because an insurer assessing a storm claim will ask about the cause and the date. The insurance claim documentation page sets out what to keep and in what order.